焦化發電機組運行結束后需要做哪些保養工作？今天小編來解答一下，焦化發電機組停機前，要先將負荷慢慢切斷，再關閉輸出空氣開關，等其減速至怠速運轉狀態三到五分鐘之后再關機，接著需要做以下6項保養工作：

What maintenance work should be done after the operation of the coking generator unit? Today, I would like to explain that before the shutdown of the coking generator unit, the load should be cut off slowly, then the output air switch should be turned off, and then the unit should be shut down after it slows down to the idle running state for three to five minutes. Next, the following six maintenance works should be done:

1、著重檢查并擰緊各旋轉部件螺栓，特別是噴油泵、水泵、皮帶輪、風扇等連接螺栓，同時緊固地腳螺栓。

1. Check and tighten the bolts of all rotating parts, especially the connecting bolts of fuel injection pump, water pump, belt pulley, fan, etc., and tighten the foundation bolts.

2、檢查是否有三漏現象，必要時清理

2. Check whether there is "three leakage" and clean it if necessary

3、排除在焦化發電機組運轉中所發現的簡易故障及不正?，F(xiàn)象四、清理焦化發電機組空氣濾清器濾芯上的塵土

3. Eliminate the simple faults and abnormal phenomena found in the operation of the coking generator set. IV. clean the dust on the air filter element of the coking generator set

4、檢查焦化發電機組機油液面和噴油泵的油面，必要時添加品質可滿足技術要求的機油。

4. Check the oil level of the coking generator set and the oil level of the fuel injection pump, and add the oil with the quality meeting the technical requirements if necessary.

5、檢查焦化發電機組水箱冷卻水液面，必要時添加軟純凈水。

5. Check the cooling water level of the water tank of the coking generator unit, and add soft purified water if necessary.

6、檢查焦化發電機組控制系統的電氣連線是否有松動八、全面清潔焦化發電機組表面。

6. Check whether the electrical wiring of the control system of the coking generator set is loose. VIII. Clean the surface of the coking generator set comprehensively.

停機后注意事項：

Precautions after shutdown:

斷開發電機輸出斷路器（手動模式下）?？刂破岭婅€匙開關轉向OFF位置，取出鑰匙，妥善保管（手動模式下）。焦化發電機組在自動模式停機后將處于待機狀態，以備隨時應急啟動。長時間停機或進行焦化發電機組維護保養時，須將焦化發電機組啟動蓄電池負極電纜拆除。在寒冷的冬季，請將發動機冷卻液釋放干凈，以免凍壞發動機缸體等，導致重大故障發生。

Disconnect the generator output circuit breaker (in manual mode). Turn the electric key switch of the control panel to the off position, take out the key and keep it properly (in manual mode). After shutdown in automatic mode, the coking generator unit will be in standby state for emergency start at any time. During long-term shutdown or maintenance of the coking generator set, the negative cable of the starting battery of the coking generator set must be removed. In cold winter, please release the engine coolant to avoid freezing the engine block and causing major failure.

以上有關于焦化發電機組運行結束后需要做哪些保養工作介紹，如有不明白可以咨詢亞南電機，關注我們網站http://m.elmasticar.com為您解答解惑。

The above is about the maintenance work that needs to be done after the operation of the coking generator unit. If you don't understand, you can consult YA'NAN Electric Co., Ltd. and follow our website http://m.elmasticar.com I'll answer your questions.