瓦斯發電機組發電質量良好，啟動快，工作穩定，機組優點多。但是這也需要在使用的時候注意一些事項。例如機組的開機與停機事項。小編介紹瓦斯發電機組組開機、停機一一做好，步驟要明了！

The gas generator set has good power generation quality, fast startup, stable operation and many advantages. But it also needs to pay attention to some matters when using. For example, the startup and shutdown of the unit. The editor introduced that the startup and shutdown of the gas generator set should be done one by one, and the steps should be clear!

一、事項要注意：

1、 Precautions:

1、開機前，應清理機組（旋轉部件）上放置的雜物（如盤車杠、工具、螺釘等），以免開車時工件飛出去傷人。

1. Before starting the machine, the sundries (such as turning bar, tools, screws, etc.) placed on the unit (rotating parts) should be cleaned to prevent the workpiece from flying out and hurting people during driving.

2、開機前手動盤車時，注意先斷開起動電源，以免誤觸動起動按鈕，盤車杠飛出去傷人。

2. When turning manually before starting the machine, pay attention to disconnect the starting power first, so as not to touch the start button by mistake, and the turning bar will fly out and hurt people.

二、發電機組運行要求

2、 Generator set operation requirements

1、啟動時，先踏下腳踏開關，按下啟動按鈕，將缸內燃氣排空后再開啟燃氣閥門，嚴禁先給燃氣再按啟動按鈕。啟動不成功或啟動后又熄火時，應關閉燃氣閥門，查清原因，排凈缸內混合氣體后，再按規定程序重新啟動。啟動成功后，應踢開腳踏開關。

1. When starting, first step on the foot switch, press the start button, empty the gas in the cylinder, and then open the gas valve. It is strictly forbidden to supply gas first and then press the start button. In case of unsuccessful startup or flameout after startup, close the gas valve, find out the cause, and restart according to the specified procedure after exhausting the mixed gas in the cylinder. After successful startup, kick the foot switch.

2、開機時，打開門窗，開動排風裝置，直到停機。

2. When starting the machine, open the doors and windows and start the exhaust device until it stops.

3、操作者在機房?jì)炔僮鲿r(shí)，應戴安全帽或頭盔，機器運轉過程中不能直接面對防爆門，應避開飛輪等高速旋轉件，不能觸摸排氣管等高溫件。

3. When operating in the machine room, the operator should wear a safety helmet or helmet. During the operation of the machine, the operator should not directly face the explosion-proof door, should avoid high-speed rotating parts such as flywheel, and cannot touch high-temperature parts such as exhaust pipe.

4、運行中，若發現燃氣有泄漏情況，操作人員應卸掉負荷并停機檢查。

4. During operation, if gas leakage is found, the operator should unload the load and stop the machine for inspection.

5、機組運行時，注意燃氣發動機防爆安全門，一旦爆破（其聲音較大）應關閉氣源，換防爆膠皮后方可重新啟動。

5. When the unit is running, pay attention to the explosion-proof safety door of the gas engine. In case of explosion (its sound is loud), turn off the air source and replace the explosion-proof rubber before restarting.

三、發電機組停機應采取的措施

3、 Measures to be taken for generator unit shutdown

1、正常停機時，應先使機組在怠速運轉至水溫、油溫降到60℃以下后再切斷氣源停機。

1. During normal shutdown, the unit should be idled until the water temperature and oil temperature drop below 60 ℃, and then cut off the air supply and shut down.

2、緊急停機后，應“盤車、泵油”至水溫、油溫降到60℃以下后再切斷氣源停機。

2. After emergency shutdown, cut off the air supply and shut down the machine after "turning and pumping oil" until the water temperature and oil temperature drop below 60 ℃.

3、停機后，應將“電磁閥電源”開關置于“關（OFF）”位置，并關閉燃氣總閥門。

3. After shutdown, turn the "solenoid valve power" switch to the "off" position and close the main gas valve.

以上就是問題解答的相關內容了，希望能夠幫助到大家，如對這一問題還存在任何疑問，都歡迎關注我們網站http://m.elmasticar.com并咨詢我們的工作人員，將竭誠為您服務。

The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://m.elmasticar.com And consult our staff, will serve you wholeheartedly.