沼氣發動機長期放置的注意事項
有時,沼氣發動機組在不使用時會(huì )被擱置很長時間。錯位時間長了,再啟動就容易失靈。那么沼氣發動機長期放置的注意事項如下:
Sometimes, biogas engine sets will be put aside for a long time when they are not in use. If the dislocation time is long, it is easy to fail when restarting. The precautions for long-term storage of biogas engine are as follows:
1.在進氣口加入少量水機油,盤車使其附著在活塞頂部、氣缸套內壁和氣門密封面上,將氣門設置在關閉狀態,使氣缸套與外界隔絕。
1. Add a small amount of water and oil into the air inlet, turn it to attach it to the top of the piston, the inner wall of the cylinder liner and the valve sealing surface, and set the valve in the closed state to isolate the cylinder liner from the outside.
2.當確定沼氣發動機不會(huì )長時間使用時,要盡可能排干冷卻水和潤滑油。讓沼氣發電機組干凈。
2. When it is determined that the biogas engine will not be used for a long time, the cooling water and lubricating oil should be drained as far as possible. Clean the biogas generator set.
3.蓋住空氣濾清器、排氣管和油箱,防止灰塵落入。
3. Cover the air filter, exhaust pipe and oil tank to prevent dust from falling.
4.確保沼氣發動機組清潔。去除表面的灰塵和油污。
4. Ensure that the biogas engine set is clean. Remove dust and oil on the surface.
5.取下沼氣發動機的氣門蓋,用刷子涂上少量無水機油,刷在搖臂等部位。
5. Remove the valve cover of the biogas engine, apply a small amount of anhydrous oil with a brush, and brush it on the rocker arm and other parts.
6.沼氣發動機應放置在通風良好、干燥和清潔的地方。嚴禁與化學品(如化肥、農藥)一起存放。
6. The biogas engine should be placed in a well-ventilated, dry and clean place. It is forbidden to store with chemicals (such as fertilizers and pesticides).
在選購沼氣發電機組時的幾點建議:根據沼氣產量,選擇合適的裝機容量,防止機械設備閑置或沼氣浪費;當采用多臺發電機組時,宜采用1000KW左右的同一規格型號,以減少運行費用和備件儲存。更多相關內容來我們網站http://m.elmasticar.com咨詢!
Several suggestions when purchasing biogas generator units: select appropriate installed capacity according to biogas output to prevent mechanical equipment from being idle or biogas waste; When multiple generator sets are used, the same specification and model of about 1000KW should be used to reduce the operation cost and spare parts storage. Come to our website for more relevant content http://m.elmasticar.com consulting service